Frigidaire Affinity Dryer Not Drying in San Leandro: Heating Element Replacement

Location: San Leandro, CA

Appliance: Frigidaire Affinity dryer by Electrolux, model FAQE7011LW0, serial 4D12504991

Customer complaint: The dryer was running but not drying clothes properly.

Cause: The heating element had failed, so the dryer could not produce the heat needed for a normal dry cycle.

Repair completed: We replaced the dryer heating element and checked the exhaust airflow to make sure air was moving out correctly.

Result: After the repair and final test, the dryer heated correctly and the San Leandro customer was happy with the result.

Diagnosis: Frigidaire dryer not drying in San Leandro

The customer in San Leandro called because the dryer was not drying clothes. A dryer can tumble normally and still leave clothes wet when the heating circuit fails, airflow is blocked, or a safety thermostat opens. During diagnostics on this Frigidaire Affinity dryer, we confirmed that the failed part was the heating element.

The model label identified the appliance as a Frigidaire Affinity dryer manufactured by Electrolux Home Products, model FAQE7011LW0. Recording the model number is important because heating components should always be matched to the exact dryer model before installation.

Heating element replacement

After the replacement part was ordered, we returned to the customer in San Leandro and fully opened the dryer to access the heater housing. The heating element is installed inside the metal heater canister, so the dryer has to be handled carefully during disassembly and reassembly.

Safety checks and exhaust airflow

While the dryer was open, we also inspected the related wiring and safety components around the heating circuit. A dryer that overheats or has poor airflow can damage heating parts again, so checking the exhaust is an important part of the repair.

Repair video

We also documented this San Leandro dryer heating element replacement in a short repair video.

Final test

After installing the new heating element, we reassembled the dryer and tested it to confirm that it was heating again. The customer was satisfied with the repair and said they would contact First Appliance Repair again for future appliance service.

If your dryer is running but not drying in San Leandro, the problem may be the heating element, thermal fuse, thermostat, control, wiring, or restricted exhaust airflow. A proper diagnosis helps avoid replacing the wrong part.