Repair Summary
- City
- Pleasanton, CA
- Appliance
- Whirlpool electric dryer, model LER8648PG1, serial MT3807902
- Replacement Parts
- Dryer heating element and door switch
- Problem
- The dryer was running but had no heat, and it also continued running when the door was opened.
- Diagnosis
- Whirlpool dryer with no heat in Pleasanton
- Cause
- The heating element had failed, and the dryer door switch was not stopping the machine when the door opened.
- Repair
- We replaced the failed heating element and installed a new door switch so the dryer could heat properly and shut off safely when opened.
- Result
- After the repair and final test, the Whirlpool dryer heated normally and stopped correctly when the door was opened.
Location: Pleasanton, CA
Appliance: Whirlpool electric dryer, model LER8648PG1, serial MT3807902
Replacement parts used: Dryer heating element and door switch. Part numbers were not visible in the service photos.
Customer complaint: The dryer was running but had no heat, and it also continued running when the door was opened.
Cause: The heating element had failed, and the dryer door switch was not stopping the machine when the door opened.
Repair completed: We replaced the failed heating element and installed a new door switch so the dryer could heat properly and shut off safely when opened.
Result: After the repair and final test, the Whirlpool dryer heated normally and stopped correctly when the door was opened.
Diagnosis: Whirlpool dryer with no heat in Pleasanton
The customer in Pleasanton called because this Whirlpool electric dryer was running but not heating. A dryer can still tumble when the heating system fails, but without heat the clothes stay damp and the cycle takes much longer than normal.
During diagnosis, we confirmed that the heating element was not working. We also found a separate safety issue: the dryer continued running even when the door was opened. That pointed to a faulty door switch, which needed to be corrected during the same visit.
Why the door switch mattered
A dryer door switch is a safety part. When the door opens, the dryer should stop tumbling right away. If the dryer keeps running with the door open, it creates an unsafe condition and should not be ignored.
In this case, the customer had two problems at the same time: no heat from the failed heating element and unsafe operation from the bad door switch. Replacing both parts was the right repair because it restored drying performance and proper door safety behavior.
Model and appliance information
The model label identified the appliance as a Whirlpool electric dryer, model LER8648PG1, serial MT3807902, type DWSR-ELE-2406026-FM54. Recording the model number is important because dryer heating elements and door switches must match the exact appliance before installation.
Repair performed
We replaced the failed dryer heating element and installed a new door switch. After reassembly, the dryer was tested for heat and for correct door switch operation.
The final test confirmed that the Whirlpool dryer produced heat again and stopped when the door was opened. The customer could use the dryer normally again with the safety function working as intended.
Repair video
This short repair video shows the same Whirlpool dryer issue: a dryer that ran constantly and did not heat until the heating element and door switch problem was corrected.
Whirlpool dryer repair in Pleasanton
If your dryer is running but not heating in Pleasanton, the problem may be a failed heating element, thermal fuse, thermostat, wiring issue, control problem, or restricted airflow. If the dryer keeps running with the door open, the door switch should also be inspected before the appliance is used again.
24FAR provides local dryer repair in Pleasanton, appliance repair in Pleasanton, and dryer repair service for Whirlpool and other major appliance brands. To book a repair visit, schedule online or call (510) 999-6091.
Schedule appliance repair today
Send us your appliance brand, symptom and city. We will help you find the next available appointment.